Q. How do you administer heparin drip?
IV continuous infusion
- Draw up 25ml of Unfractionated Heparin 1000 units/ ml in a syringe (use five vials of 5000 units/ 5ml)
- Add 25mls of 0.9% sodium chloride to produce a concentration of 500 units/ml.
- Administer via a syringe pump: Start the infusion at a rate of 2mls/hour (1,000 units/hour)
Q. How do you calculate heparin drip?
- Heparin Infusion Rate: 25,000 units = 1500 units/hour.
- 500ml.
- X (ml/hour)
- 25,000 units (X ml/hr) = 750,000.
- X ml/hr = 750,000.
- 25,000.
- X = 30 ml/hour.
Q. How many units of heparin will you administer as an initial bolus?
5.1 Document bolus in HealthLink 5.2 Use heparin 1000 units/mL vial for bolus from floor stock.
Table of Contents
Q. What should you check before administering heparin?
Prior to initiating heparin therapy, baseline labs should be drawn including: hemoglobin, hematocrit, platelet count, aPTT, and PT. The standard laboratory test to monitor therapeutic levels of LMWH is the chromogenic anti-Xa heparin assay.
Q. How do you dilute heparin?
- Cannulate the access using standard rope ladder or buttonhole protocol.
- Draw up 1000 units of heparin sodium using a 10-mL syringe and needle.
- Dilute the heparin in the syringe by drawing up sodium chloride 0.9% to a total volume of.
Q. When should heparin be held?
Preoperatively, the heparin should be stopped 6 hours before the procedure. Postoperatively, the heparin can be restarted when the surgeon agrees that it is safe, usually 6-12 hours postoperatively.
Q. Why do you monitor PTT with heparin?
PTT is commonly used in clinical practice to monitor unfractionated heparin infusion to target therapeutic range of anticoagulation and as part of coagulation panels to help elucidate causes of bleeding or clotting disorders.
