Use super glue, melted wax, or putty on your tool’s tip, latch onto the key piece with your pliers and pull the key out. If using super glue, wait for the glue to set first before pulling the key out.

After many years of use, your car key may break off in the lock. When this happens, it renders the lock unusable until you can get the broken piece out. If your car was already locked when the key broke, you will not be able to open it, and you’ll need a new key as well.

Removing a broken regular key from an ignition will typically run you between $100 to $150, depending on the severity of the repair. Some special cases will be slightly more, some slightly less. Next up are transponder keys. These are more complex keys that interact with your vehicle’s security system.

When Part of the Key Isn’t Sticking Out of the Lock By inserting it in the lock, you can try to lever or loosen the positioning of the key until part of it extrudes from the lock. At that point, you should be able to extract the broken piece with needle nose pliers or a strong magnet.

If you don’t have pliers or any sort of lock picking tools, you can use a strong magnet or an electromagnet to attract the key out of the lock. The magnet might not be able to pull the key all the way out, but will work to move it out enough to be pulled out.

Key stuck in ignition – Can an Auto Locksmith Help? Yes, an auto locksmith will be able to help remove a car key stuck in ignition, although sometimes the problem will be with the steering lock mechanism and not the actual car key.

Take your screwdriver and insert it into the ignition lock cylinder. Turn it as far round in a clockwise direction that you can. Then pull the paperclip to the right as much as you can. You should then be able to slide the switch out easily.

Turn the key so that the keyway slot is in the exact position it was in when you inserted the key; this is the correct position for the pin tumblers to align in the cylinder. With your other hand, use the tip of your finger to push firmly on the face of the plug next to the key. Gently twist and pull the key out.

Jigsaw Blades / Mini Hacksaw Blades If the keyhole is big enough, it’s sometimes possible to push the jigsaw or hacksaw blade into the top part of the keyhole, pushing it far enough back into the lock, into a position where the serrations on the blade can be used to pull the broken bit out.

Spray some Teflon dry lube into the ignition switch around the key. Just a couple of quick squirts will do the trick. Use the dental pick to actuate the pins in the ignition cylinder. This will hopefully lube the pins and lock enough so that the key can be wiggled out.

Also, a locksmith will be able to tell you whether or not it can be repaired or if you will have to get the ignition completely replaced . In this instance, you should keep in mind that the locksmith will most likely have to extract your car key before they begin any work since you have the key stuck in ignition.

Insert the tip of a pair of needle-nosed pliers into the keyhole. Try to grip the broken key and pull it out. This technique is most likely to work if the key broke at its head and all the cuts are inside the lock. If you can’t pull the key out, remove the pliers and set them aside.

To remove the ignition switch, put the key in the ignition and turn the key or switch? turn counter clockwise. Unfold a paper clip and stick the paper clip into the little hole in the switch next to the key. Then you can remove the nut and pull the switch out from the back.