There is not an official way to disable the door ajar alarm on the Ford Explorer. What You can do is open the dash board of the car, and locate the module that controls it and pull it out. If this sounds like to much work You can also find the fuse that powers it and then pull it.

Disable the plug on the back gate in order to disable the door ajar alarm on the ford explorer. If inaccessible, a module may be located beneath the dashboard.

The liftgate ajar Warning Light is located on the instrument panel. This light illuminates when your trunk is not properly closed. Secure your trunk properly, and the light will turn off.

There is a car ajar switch inside the latch of the vehicle. These switches trigger the sensors to send accurate signals to your car computer. There are about five different switches in the ford explorer. Four are located in the driver’s door, passenger’s doors, right, and left rear door.

Here is a little guide on how to remove the panel safely. Remove the connector and unplug the switch. Take a piece of wire and join the disconnected wires together and tape it. Repeat the same process for all the doors to disable the entire door ajar in your ford explorer.

The car will not be safe for parking, especially in public places, as the key fob cannot lock the doors. Door ajar malfunction is a common problem for Ford explorer users. Some of the issues: The door ajar sensor in the door hatch may get stock and malfunction. The door sensor may be faulty.

The door fault is probably one of the most common problems of the ford explorer series. The problem sometimes causes the dome light to malfunction and turn on intermittently or just stays on throughout the entire time and even when the engine is off.