With a high horsepower engine, it is better to have the belt a little tight rather than loose. A loose belt will break much more readily than a tight one. Most people do not tighten the belt to its proper tension. If you plan on “racing” or hot rodding your bike, invest in a Harley-Davidson BELT TENSION GAUGE (Part No.
Q. How do you change a drive belt on a Harley-Davidson?
How to Change the Drive Belt on a Harley-Davidson
- Place the Harley onto a motorcycle stand to get the rear wheel off the ground. Use a wrench to remove the rear wheel axle.
- Remove the belt guards with the ratchet set.
- Place the new drive belt on the transmission and rear wheel sprocket.
Q. How often should a Harley drive belt be changed?
every 5,000 miles
Q. How long do belt drives last?
Under ideal conditions, a belt should stick with you for an average of 60,000 to 100,000 miles. Pretty impressive. However, some belts are manually tensioned and may need to be adjusted. Others have a self-tensioning mechanism that can experience wear over time and may need to be serviced.
Q. How much does it cost to replace a drive belt?
The driving belt replacement cost is usually just between $100 and $200 in most cases, with the belt and part itself costing between $28 and $80, while the labor costs will be between $75 and $120 total.
Q. How do you know if your drive belt is bad?
Symptoms of a Bad or Failing Serpentine/Drive Belt
- Squealing noise from the front of the vehicle. If you notice a squealing noise coming from the front of your vehicle, it could be from the serpentine belt.
- Power steering and AC not working.
- Engine overheating.
- Cracks and wear on the belt.
Q. Is drive belt same as timing belt?
The timing belt is responsible for making sure the engine’s crankshaft, pistons, and valves operating insync or in time. The drive belt is responsible for using the engine’s revolutions to drive the power steering pump, a/c compressor, alternator, water pump, and other belt driven accessories.
Q. How long does it take to put on a serpentine belt?
For an experienced person, it will only take about 20-minutes, as the only concern will be to understand out how to loosen the tensioner bolt, and if the belt is the right one.
Q. How much does a timing belt cost?
The average cost to replace a timing belt will be anywhere from $300 to $500 in total (more for larger cars, trucks, and SUVs). The timing belt itself will usually only cost less than $50 but the majority of a timing belt job is spent on labor. The cost of the labor will be anywhere from $250 to $450 or more.
Q. How do you tell if timing belt needs changing?
If it is becoming worn, the belt will appear to look glazed or glossy on the underside. This means the rubber is getting hard and will not provide the flexibility the belt needs. Some signs are much more obvious, such as cracking or fraying. Belts with that kind of damage should be replaced immediately.
Q. Can a timing belt last 200 000 miles?
Of course the timing belt itself has to be replaced at, whichever comes first, the time or the mileage in the owner’s manual. There’s no way that these various components are going to last through two timing belts – they’re not going to last for 200,000 miles in most cases.
