Sharing Internet from Windows. Connect the two computers with an Ethernet cable. Use an Ethernet cable to connect your two computers to one another. You’ll need an Ethernet to USB-C adapter to plug into your Mac’s Thunderbolt 3 port before you can attach an Ethernet cable to a Mac.

Step 1: Connect two Computers using an ethernet cable.

1. Step 2: Click on Start->Control Panel->Network and Internet->Network and Sharing Center.
2. Step 4: Select both the Wi-Fi connection and the Ethernet connection and Right-click the Wi-Fi connections.
3. Step 5: Click on Bridge Connections.

When two or more computers are connected together so they can communicate with one another, they form a network. The Web is a series of interconnected documents stored on a computer somewhere called a site or web site.

Open System and Security. Choose System in the right panel. Select Remote Settings from the left pane to open the System Properties dialog box for the Remote tab. Click Don’t Allow Connections to This Computer and then click OK.

If your computer is hacked, you might notice some of the following symptoms: Frequent pop-up windows, especially the ones that encourage you to visit unusual sites, or download antivirus or other software. Changes to your home page. Mass emails being sent from your email account.

Running the NETSTAT -A command from the command prompt shows a large number of TCP/IP connections established by the ipMonitor software. This increased network traffic can affect ipMonitor’s ability to create new connections, especially since many existing TCP/IP connections remain in a reserved TIME_WAIT state.

The network statistics ( netstat ) command is a networking tool used for troubleshooting and configuration, that can also serve as a monitoring tool for connections over the network. Both incoming and outgoing connections, routing tables, port listening, and usage statistics are common uses for this command.

it’s waiting for a reply

I think that this is the difference: netstat will display all of the TCP connections in every State except for LISTENING. netstat -a will display all of the TCP connections in every State (including LISTENING), and it will also display the UDP listening ports.

Understanding the netstat command

1. Proto : The protocol (tcp, udp, raw) used by the socket.
2. Recv-Q : The count of bytes not copied by the user program connected to this socket.
3. Send-Q : The count of bytes not acknowledged by the remote host.
4. Local Address : The address and port number of the local end of the socket.

RELATED: How to Use Traceroute to Identify Network Problems The traceroute, tracert, or tracepath command is similar to ping, but provides information about the path a packet takes. traceroute sends packets to a destination, asking each Internet router along the way to reply when it passes on the packet.

In the case of netstat, :: (in IPv6) or 0.0. 0.0 (in IPv4) basically means “any”. So, the software is listening on TCP port 80 (the HTTP port) on any of the addresses. If you did that, then your computer might do something like listen on IPv4 192.0. 2.100:80 (or IPv6 2001:db8:abcd::1234:80).

Netstat — derived from the words network and statistics — is a program that’s controlled via commands issued in the command line. It delivers basic statistics on all network activities and informs users on which portsand addresses the corresponding connections (TCP, UDP) are running and which ports are open for tasks.