Brother Serger Not Looping One is that the needle is the wrong size. If it is too short, then it won’t catch the looper threads. There is a possibility that you did not thread in the right order so you are going to have to pull all the threads out and do it again from scratch. It is a nuisance but it has to be done.

Machine is skipping stitches There are several possible reasons for your machine to skip stitches. If the top thread is not reaching the bobbin, the threads will not lock properly, resulting in a skipped stitch. Re-thread your machine, both top and bobbin threads, and test.

Skipped stitches can mean one of two things: needle issues or disrupted timing. First, your needle may be dull or damaged and needs to be replaced. You should also check that you are using the correct needle for the type of fabric you are sewing.

1 5 Reasons Why Your Sewing Machine Keeps Jamming: 1.2 Your machine is clogged at some point or place. 1.3 The needle is deformed or broken. 1.4 The feed dogs are not functioning properly.

The thread should unwind just slightly and the bobbin case should drop an inch or two. If the thread unwinds without resistance and the case slips to the floor, your bobbin tension is too loose. If the bobbin case doesn’t budge, your bobbin tension is too tight.

Machine is not sewing any stitches while trying to sew

1. The machines top thread may not be threaded correctly.
2. Make sure the needle thread is behind the needle bar thread guide on the needle bar.
3. The thread may be knotted or tangled.
4. The thread may be too thick for the needle.